Web Content Failover is available for Web Content Connections. When enabled, multiple endpoints can be configured so that when the primary connection is unavailable the connection will fail over to the next endpoint in the list.
When a possible failover event is detected, the endpoint test similar to the one run during Connection configuration in the UI is performed. If that test does not reply with a successful test before the specified timeout period (described below), then failover to a lower priority endpoint will occur.
On the first step of the connection wizard, set the “Enable Failover” property to “Yes“.
This alters the “Endpoints” step of the Connection Wizard. With Failover enabled, a list of endpoints will appear instead of a single set of connection properties.
The order in which endpoints appear in this list is the order that the connection will use. If the primary endpoint is unreachable, then the second endpoint will be tried, and then the third, and so forth. Endpoints in the list can be reordered and disabled. Disabled endpoints will be skipped when determining the failover order.
To disable an endpoint, set Enable to “No”.
To reorder endpoints, look for a grab bar on the left where the number of the endpoint is shown. Click on the grab bar to move the endpoint up or down in the list.
There are a pair of configuration settings that determine the timing of failover checks.
(Default 60 seconds) Time in seconds between tests of all failed over endpoints to determine if failback to a higher priority endpoint should occur.
(Default 1000 milliseconds) Time in milliseconds to allow for test of endpoint to succeed before being considered down. If a server is slow to respond, this may need to be increased, but queries against an endpoint that is not responding (rather than responding immediately with an error like ‘destination not reachable’) will suffer latency while waiting to fail over.